Installation Manual

ManualsBrandsIntermatic ManualsElectricalIntermatic PF1202T Multi Circuit Freeze Protection 2 Time Switch

FREEZE PROTECTION

FOR POOLS, SPAS

AND WATER FEATURES

FREEZE PROTECTION FOR POOLS AND SPAS

INSTALLATION

OPERATION &

SERVICE MANUAL

MODEL: PF1202T

TWO CIRCUIT POOL EQUIPMENT CONTROL

WITH FREEZE PROTECTION IN RAINPROOF ENCLOSURE

ELECTRICAL RATING: 3 HP MAX. - 240 VOLT, 60 HZ.

SUITABLE FOR POOL/SPA EQUIPMENT CONTROL

DANGER! To Reduce the Risk of Injury:

...do not permit children to operate the Control Unit or use the Pool/Spa unless they are closely supervised at all times.

...test GROUND FAULT protection regularly. If it fails to reset, DO NOT USE THE POOL or SPA! Contact a qualified

service technician.

...always disconnect electricity before servicing this control or the equipment(s) connected to it. THIS CONTROL IS NOT

TO BE USED AS A POWER DISCONNECT.

READ, FOLLOW & SAVE THIS INSTRUCTION MANUAL

GENERAL INFORMATION

This Pool Equipment Control is designed to automatically operate the Filter Pump, Cleaner Pump

and also to provide freeze protection for the pool equipment. Nevertheless this product is not

intended to be a substitute for insulation, coverings, or maintenance.

THE FILTER PUMP TIME SWITCH is located in the upper left side of the enclosure and operates

the Filter Pump, as set by the trippers on the yellow dial, on a 24 hour schedule. For setting the

schedule, refer to page 3 of this Manual.

THE CLEANER PUMP TIME SWITCH is located in the upper right side of the enclosure and

operates the Cleaner Pump (Booster Pump). The trippers of this

Time Switch should be set so that the operation of the

Cleaner Pump falls within the operation of the

Filter Pump. To avoid equipment damage, the two

Time Switches are interlocked and the Cleaner

Pump would not operate unless the Filter Pump

is already operating.

THE FREEZE PROTECTION THERMOSTAT is

located in the lower left side of the enclosure

and turns ON the Filter Pump when the air

temperature (where the Control Panel is located)

drops below the temperature set by the dial

(between 32˚F and 45˚F).

Summary of content (4 pages)

PAGE 1
FREEZE PROTECTION By FOR POOLS, SPAS AND WATER FEATURES By ® FREEZE PROTECTION FOR POOLS AND SPAS INSTALLATION OPERATION & SERVICE MANUAL MODEL: PF1202T TWO CIRCUIT POOL EQUIPMENT CONTROL WITH FREEZE PROTECTION IN RAINPROOF ENCLOSURE ELECTRICAL RATING: 3 HP MAX. - 240 VOLT, 60 HZ. SUITABLE FOR POOL/SPA EQUIPMENT CONTROL DANGER! To Reduce the Risk of Injury: ...do not permit children to operate the Control Unit or use the Pool/Spa unless they are closely supervised at all times. ...
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS When installing and operating this electrical control and other associated equipment, basic safety precautions should always be followed, including the following: 1. Read and follow all instructions. 2. This Control must be installed by a qualified electrician, according to National and Local Electrical Codes. 3. Install this Control not less than 5 feet of inside edge of pool. USE COPPER CONDUCTORS ONLY. 4.
PAGE 3
OPERATION TO SET FILTER TIME SWITCH, follow instructions on the right. The length of the daily filtration/heating cycle depends on many variables such as size, shape, and geographic location of the pool, water chemistry, type of pool equipment, usage and season of year. If not sure, contact your local pool service professional for advice. TO SET CLEANER TIME SWITCH, follow instructions on the right.
PAGE 4
WIRING DIAGRAM Filter Control Time Switch 240 V. CLOCK MOTOR Cleaner Control Time Switch 240 V. CLOCK MOTOR NOTE: Ground connections are not shown and vary with installation. TB1 Team Block To Filter Pump Relay To 240 V Breaker To Cleaner Pump Equipment Ground T.