User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the CS40
- About the CS40 Mobile Computer
- Overview of CS40 Features
- CS40 Accessories
- About the CS40 Battery
- About the Keypad
- Adjusting the Volume
- Configuring Backlight Settings
- About the Status LEDs
- About the Imager
- About Bar Codes
- About the Color Camera
- Inserting a microSD Card
- How to Enable the Integrated GPS on the CS40
- Chapter 2 - Connecting and Configuring the CS40
- Chapter 3 - Developing and Installing Applications
- Chapter 4 - Troubleshooting and Maintaining the Computer
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Keypads and Keystrokes
- Appendix D - Imager Configuration Bar Codes
Chapter 1 — Using the CS40
10 CS40 Mobile Computer User’s Manual
To type a character or access a function in orange on the overlay
1 Press b. The key status LED turns orange.
2 Press the key for the character or function.
The orange modifier key stays on until you press b again.
To type lowercase letters
1 Press c. The key status LED turns green.
2 Press the corresponding number key as many times as necessary
depending on the position of the letter you want to type.
For example, to type a lowercase letter z, press
c9999.
To type uppercase letters
1 Press c 1 to turn on Caps Lock. The key status LED turns green.
2 Press the number key as many times as necessary depending on the
position of the letter you want to type.
Caps Lock stays on until you press c 1 again.
While Caps Lock is on:
• you can type orange modifier characters by pressing b and the
key for that character.
• you can type lowercase letters by pressing c and the
corresponding number key as many times as necessary
depending on the position of the letter you want to type.
For information on how to enter specific characters with keystrokes,
see Appendix C, “Keypads and Keystrokes.”
Adjusting the Volume
You can adjust the computer volume for your needs and your
environment. The volume includes sounds you hear when you tap the
screen or read bar codes with the imager. You can set the volume to
off, very low, low, medium, high, very high (default), or vibrate.