User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the CS40
- About the CS40 Mobile Computer
- Overview of CS40 Features
- CS40 Accessories
- About the CS40 Battery
- About the Keypad
- Adjusting the Volume
- Configuring Backlight Settings
- About the Status LEDs
- About the Imager
- About Bar Codes
- About the Color Camera
- Inserting a microSD Card
- How to Enable the Integrated GPS on the CS40
- Chapter 2 - Connecting and Configuring the CS40
- Chapter 3 - Developing and Installing Applications
- Chapter 4 - Troubleshooting and Maintaining the Computer
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Keypads and Keystrokes
- Appendix D - Imager Configuration Bar Codes
Chapter 1 — Using the CS40
18 CS40 Mobile Computer User’s Manual
4 Slide the microSD card door to the left to unlock it and open the
door.
5 Slide the microSD card into place.
6 Close the microSD card door and slide it to the right to lock it in
place.
7 Close the card access door.
8 Install the battery.
9 Press the Power button. The CS40 cold boots.
How to Enable the Integrated GPS on the CS40
The CS40 comes equipped with an integrated Global Positioning
System (GPS) receiver. It can deliver standards-based National Marine
Electronics Association (NMEA) data strings to GPS applications.
Intermec recommends that you use the GPS Intermediate Driver
(GPSID) instead of directly accessing the GPS hardware. The GPSID
is a Microsoft software component that interacts between
applications and the GPS hardware.
Using the GPSID allows Intermec support for Extended Ephemeris,
which enhances GPS performance by:
• reducing the amount of time it takes your GPS receiver to acquire
a fix.
• eliminating the need to obtain precise satellite data information
from the GPS satellites.