User's Manual

Chapter 2 — Connecting and Configuring the CS40
26 CS40 Mobile Computer User’s Manual
Connecting the CS40 Using 802.11 Radio Communications
Your CS40 has an 802.11 radio to transfer data using wireless
communications. This section assumes that your wireless network is
set up, including your access points.
To configure 802.11 radio parameters
1 Tap Start > Settings > Connections.
2 Tap Wi-Fi. The Wi-Fi page appears.
3 If the Network you want to connect to is available in the wireless
networks list, tap the network name and continue with Step 4.
If the Network you want to connect to is not in the wireless
networks list:
a Tap Add New. The Configure Wireless Network page appears.
b In the Network name field, enter the name of your network
and tap Next. The Configure Network Authentication page
appears.
4 From the Authentication list, choose either Open, Shared, WPA,
WPA-PSK, WPA2, or WPA2-PSK.
• If you choose Open or Shared, Data Encryption is
automatically set to WEP and the key is automatically
provided.
• If you choose WPA, Data Encryption is automatically set to
TKIP.
• If you choose WPA2, Data Encryption should be set to AES.
• If you choose WPA-PSK, Data Encryption is automatically
set to TKIP and you need to enter a Network key.
• If you choose WPA2-PSK, Data Encryption should be set to
AES and you need to enter a Network key.
Make sure all components with antennas are at least 30 cm (1 ft)
apart when power is applied. Failure to comply could result in
equipment damage.