User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the CS40
- About the CS40 Mobile Computer
- Overview of CS40 Features
- CS40 Accessories
- About the CS40 Battery
- About the Keypad
- Adjusting the Volume
- Configuring Backlight Settings
- About the Status LEDs
- About the Imager
- About Bar Codes
- About the Color Camera
- Inserting a microSD Card
- How to Enable the Integrated GPS on the CS40
- Chapter 2 - Connecting and Configuring the CS40
- Chapter 3 - Developing and Installing Applications
- Chapter 4 - Troubleshooting and Maintaining the Computer
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Keypads and Keystrokes
- Appendix D - Imager Configuration Bar Codes
Appendix A — Specifications
56 CS40 Mobile Computer User’s Manual
CS40 Docking Connector Specifications
The CS40 has an array of seven pin surface contacts that provide USB
“On the Go” (OTG) connectivity and charge power while docked.
EA11 Imager Reading Distances
Typical reading distances are done in an office environment using
office lights (4 lux). Minimum distances are measured in the dark
(0 lux). Both reading distances are provided in respective scan engine
integration guides. Contact your local Intermec representative for
more information.
Below are the typical and minimum standard reading distances for
the CS40 built with an EA11 imager. When correctly mounted, an exit
window reduces reading distances by about 4% for all scan engines.
CS40 Docking Connector Specifications
Pin Number Signal Name Description
1 VEXT Computer power
2 ID Identification pin
3 VBUS VBUS (5 V @ 100 mA max)
4D- USB data signal
5D+ USB data signal
6 GND Ground (power return)
7 GND Ground (power return)
Note: Minimum distances depend on the length of the bar code.