User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the CS40
- About the CS40 Mobile Computer
- Overview of CS40 Features
- CS40 Accessories
- About the CS40 Battery
- About the Keypad
- Adjusting the Volume
- Configuring Backlight Settings
- About the Status LEDs
- About the Imager
- About Bar Codes
- About the Color Camera
- Inserting a microSD Card
- How to Enable the Integrated GPS on the CS40
- Chapter 2 - Connecting and Configuring the CS40
- Chapter 3 - Developing and Installing Applications
- Chapter 4 - Troubleshooting and Maintaining the Computer
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Keypads and Keystrokes
- Appendix D - Imager Configuration Bar Codes
Appendix D — Imager Configuration Bar Codes
72 CS40 Mobile Computer User’s Manual
Imager Configuration Bar Codes
Use the following bar codes to quickly configure the mobile computer
imager. These bar codes allow you to enable or disable symbologies,
reset to factory defaults, and set predefined imager modes.
If you need to create a bar code for a specific setup, please download a
free copy of EasySet from the CS40 web page on the Intermec web site
at www.intermec.com.
Basic Configuration Bar Codes
Command Bar Code
Disable all symbologies
Reset to Factory Defaults
Postamble with Carriage Return and Line Feed
Imager Predefined Modes
Command Bar Code
1D codes only
Standard 1D and 2D codes