User Manual
Table Of Contents
- Before You Begin
- Using the CN4
- Connecting and Configuring the CN4
- Connecting to a PC
- Configuring the CN4 Parameters
- Configuring the Phone
- Configuring the CN4 for Your Network
- Configuring Wireless Security
- Developing and Installing Applications
- Troubleshooting and Maintaining the CN4
- Specifications
- Default Settings
- Standard Characters
- Index
Chapter 1 — Using the CN4
8 CN4 Series Mobile Computer User’s Manual
You can also check the battery status by using the Power application.
To check the battery status
• Tap Start > Settings > the System tab > Power > the Battery tab.
Understanding the Battery Status LED
Battery Status Description
Steady green The battery is more than 95% charged and
CN4 is on a charger.
Blinking red The battery is low. CN4 goes into Suspend
mode. Charge or replace the battery.
Steady red and the CN4 is
attached to external power.
The battery is charging.
Steady red and the CN4 is not
attached to external power.
The CN4 firmware is not working properly.
Cold boot the CN4 as described in “Cold
Booting the CN4” on page 84.
Steady amber The battery is missing or is unable to
charge.
If the battery will not charge, it may be
because the temperature is outside of the
charging range, or you may be using a
battery not approved by Intermec. You
need to use one of the battery models
specified in “Standard and Extended
Batteries for CN4 and CN4e” on page 4.
Off The CN4 is not on external power and the
battery is operating normally.
Battery status LED