User Manual

4 PB3 Mobile Printer User’s Guide
Using the Battery and AC Adapter/Charger
To install the battery
1 Slide the battery door latch toward the belt loop knob to unlock
the battery door, and open the battery door to an angle of about
90 degrees. Do not force the door all the way open.
2 Orient the battery so the arrow points toward the battery contacts
in the battery compartment.
3 Insert the end of the battery without contacts into the battery
compartment first. The contact end drops into place.
Installing the PB3 Battery
Use Intermec battery model 318-040-001 only. Use of another
battery may present a risk of fire or explosion.
The battery used in this device may present a fire or chemical
burn hazard if mistreated. Do not disassemble, heat above 80°C
(176°F), or incinerate.
Note: The battery must be cycled several times to achieve maximum
capacity. To cycle a battery, fully charge it and then allow a full
discharge through normal use. To ensure a full charge, do not operate
the printer while charging the battery.
Be sure you insert the battery correctly, or you may damage
the battery contacts in the printer.