User Manual

10 PB3 Mobile Printer User’s Guide
Tearing Paper
The paper door acts as a tear bar. Pull one edge of the paper against
the tear bar, and then tear down and across against the tear bar to tear
the paper.
Printing a Configuration Test Page
Once the battery is charged and paper is loaded, you can print a
configuration test page. Use this information for reference when
installing the PB3 and to verify correct printer operation. If you
cannot print the test page, see “Troubleshooting” on page 18.
To print a test page
1 Make sure the printer is off before you begin.
2 Press and hold the Feed button.
3 Press the Power button once to turn on the printer. When the
printer starts printing the test page, release the Feed button.
4 To stop or cancel printing the test page, press either the Power or
Feed button.
Note: Using the tear bar is the only way to tear the paper. Pulling up
and pulling sideways without using the tear bar can cause a paper jam.
The tear bar has sharp edges. Be careful when tearing paper or
when handling the paper door.
Note: If you are using the AC adapter/charger as a power source, the
printer will not print unless a battery is installed.