User Manual

PB3 Mobile Printer User’s Guide 15
2 Change DIP switch settings by carefully pressing a pointer into the
switch and sliding it to the other side. For more information, see
the next table.
3 Install the battery in the printer and close the battery door. The
printer is now configured for your connection.
DIP Switch Settings
Turn These DIP Switches On
To Set This Parameter 1 2 3 4 5 6 7 8
Enable serial connection
Enable Bluetooth or 802.11 connection X
Set baud rate: 115200
57600 X
38400 X
19200 X X
14400 X
9600 X X
2400 X X
1200 X X X
Parity Bit Enabled X
Disabled
Odd/Even Even X
Odd
Auto Power Save Enabled X
Disabled
Note: If you are configuring the PB3 for a Bluetooth or 802.11
connection, make sure DIP switches 3, 4, and 5 are off.