User's Manual
Table Of Contents
- Send Feedback
- Before You Begin
- Chapter 1 - About the Computer Features
- About the 70 Series Mobile Computers
- 70 Series Accessories
- About Language Provisioning
- About the Battery
- About the Keypad
- Configure the Screen Backlight
- Configure the Screen Brightness
- Adjust the Volume
- About the Imager
- Use the Imager as a Flashlight
- Read Bar Codes
- Insert a MicroSD Card
- Transfer Files To and From Your PC
- Chapter 2 - About the User Interface and Intermec Applications
- Chapter 3 - Use the Phone
- Chapter 4 - Use the Camera
- Chapter 5 - Use GPS
Chapter 1 — About the Computer Features
30 70 Series Mobile Computer User Manual
Scanning With the EA30 Imager
5 Use the laser pointer as a guide and aim toward the middle of the
bar code. Make sure that the illumination beam or frame covers the
bar code you are trying to decode.
When the computer successfully reads a bar code label, you hear a
high beep, and the Good Read LED turns on briefly.
6 Release the Scan button.
Insert a MicroSD Card
You can use a microSD™ card to increase file storage and install
software. The computers support an optional 32 GB maximum
capacity microSD card.
Install a MicroSD Card in a CN70 or CN70e
You need a Phillips screwdriver to install the microSD card.
1 Press the Power button to turn off the computer.
2 Remove the handstrap and the battery.
Note: The computer resets when you open the card access door to
insert the microSD card. Make sure you completely close the card
access door before you use your computer.