User's Manual Part 1

Chapter 3 — Using the Phone
52 70 Series Mobile Computer User Manual
8 Install the battery. Press down firmly on the bottom of the battery,
and make sure that the battery release tab is fully engaged.
9 Press the Power button. The computer cold boots.
Activating the CDMA Phone
To activate the CDMA radio module in your mobile computer, you
need to contact your wireless carrier and set up an account for each
mobile computer. The following table lists the carriers that Intermec
currently supports. If your carrier is not listed in the table, please
contact Intermec product support to see if it is now supported.
Currently Supported Carriers
The carrier will require the Electronic Serial Number (ESN) to start the
activation process. You can find the ESN:
• on a label located in the upper right corner of the battery
compartment.
• on the outside of the computer shipping box.
The activation process is slightly different for each CDMA carrier.
Your carrier sales contact and an Intermec representative can guide
you through the process.
After you supply the ESN to your carrier, they will respond with values
that you must enter using the Windows Mobile Activation Wizard (if
required). Some of the supported carriers do not require you to enter
any values. The following table shows the carriers, the correct
activation method to use, and the values that you need to activate your
phone.
Country Carriers
United States Sprint, Verizon
DRAFT