Manualshelf

User's Manual

ManualsBrandsIntermec Technologies ManualsComputers & AccessoriesMobile Computer
1234
U.S. Digital Emissions
C
o
m
p
li
an
ce
This device complies
with part
15 of
the
FCC Rules.
Operation
is subject to
th
e
following two co
ndit
ion
s
:
(1) This device may
not
cause harmful
interference, and (2) This device must accept any interference received, including
interference that
can cause undesired
op
era
t
i
o
n
.
This
equipment
has been
tested
and found
to
comply with
the
limits for a Class B
digital
device,
pursuant to Part
15 of the FCC Rules. Thes
e
limits
are designed
to
provide reasonable
protection against
harmful interference in a residential
in
st
al
lat
i
on
.
This
equipment
generates,
u
s
es,
and can
radiate
radio frequency energy and, if
not
installed and used in accordance
with the in
stru
ction
s
,
may cause harmful interference
t
o
radio
commun
i
cat
i
on
s
.
However, there is no guarantee
that
interference will
not
occur in a
particular in
st
allation
.
If
this equipment
d
o
e
s
cause harmful interference
to
radio or television reception, which can be determined by
turning
the
equipment
off and on, the user is
encouraged to try to correct the interference by one or more of the following meas
ur
e
s
:
• Reorient or relocate the radio or television receiving
ante
nn
a.
• Increase the separation between the computer equipment and receiver.
•
Connect the equipment
into an
outlet
on a
circuit different
from
that to
which the radio or television receiver is
c
o
nn
ec
t
e
d
.
•
Consult
the dealer or an experienced radio television technician for
h
e
l
p
.
Canadian Digital Apparatus
C
o
mpliance
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device."
"Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."
This Class B
digital apparatus
meets all
requirements
of
the
Canadian Interference-Causing
Equipment
Regulations ICES-3.
802.11a Radio Pre
c
auti
on
Statement
(CK3X, Model
1
0
07C
P
02
Only)
• 802.11a wireless
LAN
5150 to 5250 MHz (5.15
to
5.25 GHz) (5 GHZ radio channels 34 - 48) is restricted
to
indoor
operations
to
r
ed
uc
e
harmful interference
to
co-channel Mobile Satellite System (MSS)
op
era
t
ion
s
.
• The maximum antenna gain
permitted
for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p. li
m
i
t.
• The maximum antenna gain
permitted
for devices in the band 5725-5825 MHz shall comply with the e.i.r.p.
limits
specified for
p
oint-
topoint
and non
poi
n
t
-
to
-p
oin
t
operation
as a
ppropr
ia
t
e
.
•
Be
advised
that
high-power radars are allocated as primary users
(i.e.
priority users) of the bands 5250-5350 MHz and 5650-5850 MHz
an
d
that these
radars could cause interference
and/or
damage
to
LE-LAN
devices.
For Users in
Europe
Laser and Imager Compliance and
Precaution
This
product
complies with the following
standards
for laser and LED safety
:
• IEC 60825-1:2007/EN 60825-1:2008-05
:
Class 2 (1 mW, 630-680
nm)
• IEC 60825-1/EN 60825-1: Class 1 LED
Product
(imaging options only, no laser labe
l)
If applicable,
this product
will be provided with a set of laser safety labels
illustrated
on the last page of this document. If
the
proper label
language is
not
installed on the
device,
locate and apply the
appropriate
label over
the
existing label.
Caution: For
CK3X
(Model 1007CP02) only, 802.11a wireless
LAN
5150
to
5350 MHz (5.15 to 5.35 GHz) is limited to indoor use
on
ly
.
Note
:
Dynamic Frequency Selection and Transmit Power Control are required in the 5250 to 5350 MHz and 5470 to 5725 MHz freq
uenc
y
range.
EU
-
R&TTE
Declaration
Intermec Technologies
Corporation
declares
that this
device is in compliance
with
the essential
requirements
and other relevant provisions of
R&TTE Directive (1999/5/EC). To find the EU Declaration of Conformity, go to www.intermec.com > Products > Computers >
Handheld
Computers > CK3 > Manuals tab and
then
scroll down
to
Regulatory
Information
.
This
product
is marked with this logo and uses radio frequency bands
that
are
harmonized throughout the Euro
pe
an
Community
.
For
CK3X
(Model 1007CP02) only, this
equipment
may be operated in
the
following countries
without restr
i
ctio
n:
AT
BE
CY
CZ
DK
EE
FI
DE
GR
HU
IE
LV
LT
MT
NL
PL
PT
SK
SI
ES
GB
IS
LI
CH
BG
R
O
Fo
r CK3R (Model 1007CP01) only, this
equipment
may be operated in the following countries
without restri
ction:
AT
BE
CY
CZ
DK
EE
FI
DE
GR
HU
IE
LV
LT
MT
NL
PL
PT
SK
SI
ES
GB
IS
LI
CH
BG
R
O
TR
2