User's Manual

Network SupportChapter —4
140 700 Series Color Mob ile Computer User’s Manual
WAN Monitor — Details
Note: See page 130 for information on loading this module in CORE.
Below are descriptions and meanings for each piece of information pro-
vided via the Details tab. Most of this is similar to what is shown under
the General tab. Note that the information is listed alphabetically.
ESN Lists the Electronic Serial Number (ESN) assigned to this radio module or “Unavailable” if a num-
ber cannot be read from the radio. This number is required for activation. You must provide this
number to your service provider, such as Sprint, Verizon, Bell Mobility, etc. , for activation. Note
that both the hex version and the decimal version of your ESN is provided.
Firmware Rev Identifies the firmware version, if available.
Firmware Type Identifies the type of firmware ins talled in the WAN radio module. It should match th e carrie r
you are using as your netw ork provider.
Hardware Re v Identifies the hardware revision of the WAN radio module installed in your unit.
IMSI/MIN Shows the IMSI (International Mobile Subscriber Identity) number assigne d to the Su bscriber
Identity Module (SIM) card installed in this 700 Serie s Computer.
Manufacturer Lists the name of the manufactu rer that developed this radio module, s uch as “Sierra Wireless.”
MDN Shows the MDN (Mobile Directory Number) or DN (Directory Number) — the number that
identifies the account tied to your device. You can consider this the “phone number.” Note that
the MDN and IMSI/MIN numbers can be the same.
Model Lists the product name for this radio module, such as “Model 72.”
Phone Number Identifies the telephone assigned to the WAN radio module.
PRI Version Provides the version number of the Preferred Roaming List (PRL).
Radio Temp Identifies the te mperature of the radio module, or lists “Unavailable degrees” if no information or
temperaturecannotbemeasured.
Rx (abbreviation for receive) Indicates the number of bytes received over the WAN connection s ince
the CORE WAN Module was started.
Tx (abbrevia tion for transmit) Indicates the number of bytes received over the WAN connection since
the CORE WAN Module was started.