User's Manual Part 3
Table Of Contents
- Checking the Power Source
- Aligning the Printer Mechanism
- Troubleshooting System Components
- Understanding Diagnostic Information
- Communications Pin-Out Configurations
- Specifications
- Printer Dimensions
- Media Specifications
- Understanding the Fanfold Paper Page Layout
Chapter 6 — Troubleshooting
6822 Series 80-Column Printer User’s Manual 99
2 Check the area between the printhead and the printer cavity. If the
ribbon cartridge touches the pivot frame, the printer mechanism
needs realignment.
Printhead at far left in the printer
3 Loosen the four screws that hold the mechanism in place using a
Phillips screwdriver (see the following illustration).
4 Push the printer mechanism to the right away from the green thumb
wheel.
5 Press on the right side of the printer mechanism to the back as far as
it will go.
Pivot frame
Note: In this position, the right back edge of the printer
mechanism may touch the pivot frame. The left side must not
touch the pivot frame.