User's Manual

Chapter 1 — Getting Started
IP30 Handheld RFID Reader User’s Guide 5
About the Intermec Ready-To-Work Indicator
The blue Ready-to-Work Indicator
TM
shows when a connection is
established between your mobile computer and IP30. The next
table explains the different states of the Ready-To-Work
Indicator.
The IP30 enters low power mode if there is no host activity after
5 minutes. The IP30 will remain Ready-To-Work as long as the
mobile computer maintains a a communications link. To
determine if the IP30 is ready to work, pull the trigger.
Understanding the Ports
The USB version of the IP30 for the CK61 has two ports located
on the IP30 adapter. To access these ports, you must remove the
port cover.
To remove the port cover
• On bottom of the IP30 adapter, remove the port cover by
pulling away from the right side of the port cover.
LED Description
Off The IP30 is not yet ready for operation, or the IP30
is in low power mode.
Blinking The IP30 is not associated with or connected to
the mobile computer.
Steady A connection has been established between the
IP30 and the mobile computer.
Power port
COM 1