User's Manual

Chapter 1 — Using the Computer
4 CK3 Mobile Computer User’s Manual
For replacement batteries, contact your Intermec representative.
Charging the Battery
Make sure you fully charge the AB17 or AB18 battery before you use
your CK3. You can charge the battery before or after you install it in
the CK3. A fully discharged battery charges in approximately 4 (AB17)
to 7 (AB18) hours.
To charge the battery
• Insert the battery into the battery bay of the AD20 single dock, or
insert up to four batteries into the AC20 quad battery charger.
Or,
• Install the battery in the CK3 and insert the CK3 into the AD20
single dock, AD21 ethernet multidock, AD22 charge-only
multidock, or AV10 vehicle dock.
Use the next table to understand how long it takes to charge your
batteries in each of the CK3 charger or dock accessories.
Removing and Installing the Battery
To maximize the time allowed to replace the main battery pack, put
the CK3 in suspend mode before removing the battery pack.
Note: If the CK3 is not using external power and you remove the
battery pack, the CK3 goes into Suspend mode.
Charging Times for CK3 Batteries
CK3 Charging Accessory AB17 Charging Time AB18 Charging Time
AC20 quad battery charger up to 4 hours up to 6 hours
AD20 single dock up to 4 hours up to 6 to 7 hours
AD21 ethernet multidock up to 4 hours up to 7 hours
AD22 charge-only multidock up to 4 hours up to 7 hours
AV10 vehicle dock up to 4 hours up to 7 hours