User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Chapter 2 - Connecting and Configuring the CK3
- Connecting to a PC
- Configuring the CK3 Parameters
- Configuring the CK3 for Your Network
- Configuring Wireless Security
- Chapter 3 - Developing and Installing Applications
- Chapter 4 - Troubleshooting and Maintaining the CK3
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Keypads and Keystrokes
- Index
Chapter 1 — Using the Computer
CK3 Mobile Computer User’s Manual 23
• Choose a Predefined mode in Intermec Settings:
a Tap Start > Settings > the System tab > Intermec Settings.
b Tap Data Collection > Internal Scanner > Imager Settings >
Predefined Modes and then select one of these options:
Using a microSD Card
You can use a micro Secure Digital (SD) card to increase file storage
and install software. You CK3 supports microSD cards that hold up
to 2 GB of information. The microSD card slot is located in the
battery compartment.
To install a microSD card
1 Remove the battery. For help, see “Removing and Installing the
Battery” on page 5.
2 Slide the microSD card cover toward the OPEN position and lift
the cover.
Predefined Mode Select if You Are Scanning:
1D Only 1D labels.
1D and 2D
Standard
All types of bar code labels.
1D and 2D Bright
Environment
In high ambient light, such as outdoors in the
sunshine.
1D and 2D
Reflective Surface
Glossy labels.
Custom In conditions that require customized settings.
For more information about these settings,
commands, and parameters, see the Intermec
Settings Command Reference Manual available from
the Intermec web site at www.intermec.com.