User's Manual

Chapter 2 — Connecting and Configuring the CK3
CK3 Mobile Computer User’s Manual 31
Configuring the CK3 for Your Network
The CK3 is a versatile mobile computer that you can easily add to
your wireless or wired data collection network. You can connect your
CK3 using:
• 802.11b/g radio communications.
• Bluetooth communications.
• Ethernet communications
• USB and serial communications.
Configuring 802.11b/g Radio Communications
Your CK3 has an 802.11b/g radio to transfer data using wireless
communications. This section assumes that your wireless network is
set up, including your access points.
To configure 802.11b/g radio parameters
1 Tap Start > Settings > the Systems tab >Intermec Settings.
2 Tap Communications > 802.11 Radio > Funk Security >
[Profile #] > SSID.
3 Enter your SSID (network name).
4 If you are not using DHCP, tap IP Settings and configure your
network settings.
5 Make sure that your CK3 is talking to the network and that the
network can see your CK3.
6 Configure security. For help, see “Configuring Wireless
Security” on page 40.
Make sure all components with antennas are at least 30 cm (1 ft)
apart when power is applied. Failure to comply could result in
equipment damage.