Quick Start Guide

4 IM5 Reader Module Installation and Quick Start Guide
Installing the IM5 Reader Module
The IM5 Reader Module requires 8-10 volts DC at 2 amps.
The IF4 Serial Reader is powered through a 2-pin bulkhead bar-
rel connector (Switchcraft p/n: 712A).
The Reader Module supplies 9-volt 2.4 amps to this connector.
Mating plugs for this connector are Switchcraft part numbers
760, 760K or 761K. A cable within the PSR connects the bulk-
head barrel connector, via an endplate switch, to the 2-pin Mo-
lex connector on the IM5 Reader Module.
IM5 Reader module
Cable connector
Auxiliary I/O
Connector
RS-232 port
The IM5 Reader Module has holes along the sides that can be
used for mounting. For best results, attach heat sink to case via
the screwholes in the heat sink.
Screw holes
IM5 Reader module