User's Manual

NOVATEL WIRELESS
TECHNOLOGIES LTD.
Calgary, Alberta
TITLE:
Hardware Interface Specification for
Expedite Wireless IP Modem
DOCUMENT NO.:
OM-01016529
SHEET:
15 of 17
REV:
3.0
CDPD
Part 409
Specification Parameter Condition Upper Limit Lower limit
Watts) dB
5 INSTALLATION INSTRUCTIONS
Unless the final product satisfies SAR (Specific Absorption Ratio) compliance through separate FCC
approval, integration of this module into other products has some requirements which are outlined below.
5.1 Antenna Mounting
The antenna must be mounted at a location such that no person(s) can come closer than 20 cm (7.9
inches) to the antenna when the transmitter is operating.
5.2 Antenna
This module is limited to operate with an antenna with maximum of 2.15 dBi nominal gain or not to
exceed 1.5 Watts ERP for any type of remotely mounted outdoor external antenna.
5.3 Labeling
The following label, visible to all persons exposed to the transmitter, must be provided on the end
product unless SAR compliance can be demonstrated:
5.4 User Manual
You must also provide the above warning in the user manual for the end product and also include the
following:
Do not substitute any antenna for the one supplied by the manufacturer. You may be exposing
person(s) to harmful radiation. contact the supplier or manufacturer for further instruction.
Warning : All persons must
be at least 20 cm from
antenna when transmitter
operating to meet FCC RF
exposure requirements
46.00mm.
25.40mm.