User's Manual Part 2

Chapter 3 — Troubleshooting and Maintaining the Printer
PD41 and PD42 Commercial Printer User’s Guide 77
If you are having detection problems, you can test the label stop
sensor in Setup mode. The label stop sensor tests can determine
whether the sensor is in the right position, if it is blocked by dust or
stuck labels, or if it is defective in some way. Setup mode has these two
test functions:
• LSS Auto: Checks to make sure that the label stop sensor is
working properly and can detect gaps, slots, and black marks.
• LSS Manual: Shows the sensor setting established by the latest
Testfeed. LSS Manual is intended to be used by Intermec service
personnel only.
To run the LSS Auto test
1 Make sure the printer is correctly configured for the type of media
you are using.
2 Press Testfeed ( ).
3 Make sure that there is a label, not a gap or black mark, at the
sensor.
Point of
detection
Test