User's Manual Part 2

Chapter 2 — Connecting and Configuring the Printer
PD41 and PD42 Commercial Printer User’s Guide 29
1 Start PrintSet on your PC.
2 In the General Tasks box, click Add Printer and step through the
screens of the Add Printer Wizard until you have successfully
added your printer.
3 In the Printer Tasks box, click Wireless Setup Wizard and step
through the screens to set up wireless network and security
parameters.
To set up the printer for wireless communications using
Hyperterminal
1 Connect one end of the RS-232 cable to the back of the printer and
connect the other end of the cable to a serial COM port on the PC.
2 On your PC, open HyperTerminal® and set these serial port
parameters:
.
3 From the host PC, check the wireless settings.
If you are using IPL, send these commands to the printer:
<STX><SI>wt,SSID<ETX>
<STX><SI>wt,WEP1<ETX>
<STX><SI>wt,WEP2<ETX>
<STX><SI>wt,WEP3<ETX>
<STX><SI>wt,WEP4<ETX>
<STX><SI>wt,AUTH<ETX>
<STX><SI>wt,WPA<ETX>
<STX><SI>wt,WPA2<ETX>
<STX><SI>wt,WPA_PSK<ETX>
<STX><SI>wt,ROAM<ETX>
<STX><SI>wt,PWR_MODE<ETX>
<STX><SI>wt,CHANNEL<ETX>
<STX><SI>wt,AP_MAC<ETX>
<STX><SI>wt,SIGNAL<ETX>
<STX><SI>wt,SPEED<ETX>
<STX><SI>wt,ACTIVE<ETX>
Parameter Default Setting
Baud rate 9600
Data bits 8
Parity None
Stop bits 1