User's Manual

Chapter 1 — Using the PB50 Mobile Label Printer
PB50 Mobile Label Printer User’s Guide 13
4 Feed the label liner over the self-strip bar and out the back of
the self-strip door.
5 Close the media cover until it latches and press down on the
self-strip door to make sure it locks.
Printing a Testprint
After you have loaded media in the printer, you are ready to print
a testprint. You can choose from several testprint options for each
type of firmware. If you cannot get the testprint information to
print, see “Troubleshooting the PB50” on page 38.
To print a test print with a PB50 loaded with IPL firmware
1 Press the Setup button.
2 Press until you reach Te s t / S e r v i c e .
3 Press to enter the Test/Service menu system.
4 Press to enter the Testprint Config menu.
5 Press to enter the Config menu.
6 Press to choose a testprint.
7 Press to print the Config testprint of your choice.