User's Manual

Chapter 6 — Configure the Computer
70 Series Mobile Computer User Manual 101
9 If you selected PEAP:
a Load a root certificate of the authentication server on your
computer. For help, see “Load a Certificate” on page 102.
b Press OK to save the security settings and the User Logon dialog
box appears.
c Enter a User Name, Password, and Domain. Select Save
Password if you want to save the password for future
authentication sessions.
d Press OK to save the Microsoft Security settings.
10 For Network Key Setting, select Automatic.
11 Save your settings.
Configure Static WEP Security with Microsoft
Use the following procedure to configure static WEP security with
Microsoft security. Intermec recommends that you use WPA2-PSK
instead of WEP if possible.
1 Make sure the communications and radio parameters on your
computer are configured.
2 Start Intermec Settings.
3 Select Communications > 802.11 Radio > Microsoft Security.
4 For Network Authentication, select Open.
5 For Data Encryption, select WEP.
6 For Network Key Setting, select Enter Key and Index.
7 For Network Key Value, enter an ASCII key or a hex key that is
either 5 bytes or 13 bytes long depending on the capability of the
radio.
Set a 5-byte value for 64-bit WEP or a 13-byte value for 128-bit
WEP. Hex keys must be preceded by 0x and contain 5 or 13 hex
pairs.
8 For Network Key Index, select the key you want to use for data
transmission.
9 Save your settings.