User`s manual

Chapter 3 — Configuring the CV30
CV30 Fixed Mount Computer User’s Manual 39
Setting Up 802.11 Radio Communications
The CV30 has an internal 802.11 b/g radio to transfer data using
wireless communications. This section of the manual assumes
that you have already set up your wireless communications
network including your access points. If you are using a UDP
Plus network, you also need to have your Intermec Application
Server communicating with a host computer.
The CV30 supports these network protocols:
•TCP/IP
• UDP Plus
The next sections explain the parameters you need to configure
for the CV30 to work in your wireless network.
Configuring the Network Parameters for a TCP/IP Network
In a TCP/IP network, the CV30 communicates with a host
computer directly using TCP/IP. The access point acts as a bridge
to allow communications between the wired network and the
wireless network.
To use wireless communications in a TCP/IP network
1 Go to Start > Settings > the Systems tab > Intermec
Settings.
2 Configure these network parameters on each CV30 in the
network:
• Network name (SSID)
• IP settings (if not using DHCP)
3 Make sure that the CV30 is talking to the network and that
the network can see the CV30.
4 Configure security. For help, see “Configuring Security on
the CV30” on page 41.
The easiest way to configure the network parameters on the
CV30 is to use Intermec Settings. For help, see “Configuring the
CV30 Using Intermec Settings” on page 30.