User`s manual

Chapter 3 — Configuring the CV30
CV30 Fixed Mount Computer User’s Manual 47
To enable WPA-PSK or WPA2-PSK with Funk security
1 Make sure you have configured the communications and
radio parameters on your CV30.
2 Make sure you have selected Funk as your security choice.
3 Open Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security
> Profile.
5 For Association, choose WPA or WPA2.
6 For 8021x, choose None.
7 For Pre-Shared Key, enter the pre-shared key or the
passphrase.
The pre-shared key must be a value of 32 hex pairs preceded
by 0x for a total of 66 characters. The value must match the
key value on the access point. The passphrase must be from 8
to 63 characters. After you enter a passphrase, the CV30
internally converts it to a pre-shared key.
This value must match the passphrase on the authenticator.
8 Exit Intermec Settings.
Configuring 802.1x Security With Funk Security
1 Make sure you have configured the communications and
radio parameters on your CV30.
2 Make sure you have selected Funk as your security choice.
3 Open Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security
> Profile.
5 For Association, choose Open.
6 For Encryption, choose WEP.
7 For Authentication, choose TTLS, PEAP, or TLS.
If you choose TTLS or PEAP:
a Select User name and type your user name.
b Select Password prompt, and choose Enter password
now.