User manual

Chapter 4 — Configure the Computer
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Manual 61
7 For Network Key, enter the pre-shared key or the passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the authenticator. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the computer internally converts it to
a pre-shared key.
8 For Confirm Network Key, enter the pre-shared key or the
passphrase again.
9 Save your settings.
Configure 802.1x Security with Microsoft Security
Use the following procedure to configure 802.1x security with
Microsoft security. Intermec recommends that you use WPA2-802.1x
instead of 802.1x-WEP if possible.
1 Make sure the communications and radio parameters on your
computer are configured.
2 Tap Start > Network Connections. The Network Connections
screen appears.
3 Tap and hold onto the Wireless Network Connection icon until
the pop-up screen appears and select Properties.
4 Tap the Wireless Networks tab.
5 Make sure your wireless network you are configuring is selected
and tap the Properties button.
6 For Network Authentication, choose Open or Shared. The
Encryption type automatically defaults to WEP.
7 For Network Key, enter the pre-shared key or the passphrase.
8 For Confirm Network Key, enter the pre-shared key or the
passphrase again.
9 Select Enable IEEE 802.1x Authentication for this network.
10 In EAP type, choose either PEAP or Smart Card or other
certificate.
11 Tap the Properties button.
12 Select Validate server certificate.