Technologies Label Maker User Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the PB50 Mobile Label and Receipt Printer
- Chapter 2 - Configuring the PB50
- Chapter 3 - Troubleshooting and Maintaining the PB50
- Appendix A - Specifications
- Appendix B - IPL and Fingerprint Setup Menus
Chapter 1 — Using the PB50 Mobile Label and Receipt Printer
12 PB50 Mobile Label and Receipt Printer User’s Guide
2 Press down on the media adjust guide and slide the two media
supports apart.
3 Insert a roll of media and press the media adjust guide until the
roll is held firmly in place. Make sure you load the media clockwise
so that it pulls off the core from the bottom of the printer.
4 Pull out approximately 8 cm (3 inches) of the media.