Technologies Label Maker User Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the PB50 Mobile Label and Receipt Printer
- Chapter 2 - Configuring the PB50
- Chapter 3 - Troubleshooting and Maintaining the PB50
- Appendix A - Specifications
- Appendix B - IPL and Fingerprint Setup Menus
Chapter 1 — Using the PB50 Mobile Label and Receipt Printer
PB50 Mobile Label and Receipt Printer User’s Guide 13
5 Close the media cover until it latches. The printer emits the
hardware sound to tell you that the media door closed correctly.
6 Press down on the self-strip door to make sure the media cover is
completely latched.
7 Press and hold the Feed button for more than two seconds to
calibrate the media.
Note: The linerless printer does not have a self-strip door. Instead,
the self-strip door is molded plastic and part of the media cover.