User Manual
Table Of Contents
- Before You Begin
- Chapter 1 — About the Printers
- Chapter 2 — Set Up the Printer
- Adjust the Media Holders
- Load Media for Straight-Through Printing
- Load Media for Cut-Off Printing
- Load Media for the Label Dispenser
- Load Ribbon
- Use External Media
- Connect the Printer to Power
- Use the Setup Wizard
- Print Print Quality Labels from the Main Menu
- Print Configuration Labels from the Main Menu
- Media Settings
- Chapter 3 — Connect the Printer
- Chapter 4 — Configure the Printer
- Chapter 5 — Troubleshoot the Printer
- Chapter 6 — Maintain the Printer
- Appendix A — Specifications and Default Settings
- Printer Specifications
- Supported Bar Code Symbologies
- Bluetooth Settings
- Display and Audio Settings
- Error, Information, and Warning Alert Settings
- Ethernet Settings
- General System Settings
- Media Settings
- Print Quality Settings
- Serial Port Settings
- System I/O Settings
- System Network Services
- System Maintenance Alert Settings
- Wireless 802.11 General Settings
- Wireless 802.11 Network Settings
- Wireless 802.11 Security Settings
- Appendix B — Print Labels with INPrint
Appendix A — Specifications and Default Settings
PC23 and PC43 Desktop Printer User Manual 157
Client Key Sets the private key the printer uses for EAP-TLS.
Maximum length is 128 characters. Use the certinstall.sh
script to install the certificate correctly.
None
Server Common
Name 1
Sets the certificate name that is on the primary
authentication server. If this value is none, then the value
for Server Common Name 2 is used. Range is 1 to 96
characters.
None
Server Common
Name 2
Sets the certificate name that is on the secondary
authentication server. If this value is none, then the value
for Server Common Name 1 is used. Range is 1 to 96
characters.
None
Validate Certificate Determines if the identity of the authentication server is
verified using its certificate when using EAP-TTLS, PEAP,
or EAP-TLS. Intermec recommends that you set Validate
Certificate to Yes.
No
PAC Sets the name of the Protected Access Credential (PAC)
that is used for EAP-FAST authentication. The printer
uses this file if Acquire PAC is on and the current installed
PAC fails to authenticate the printer to the network.
eap-fast.pac
Acquire PAC Determines if automatic PAC file provisioning is on for
EAP-FAST authentication.
On
Fast Roaming
(CCKM)
Determines if the printer can roam from one access point
to another without reauthenticating with the server.
CCKM only works in wireless networks using LEAP.
Disable
Mixed Mode
(Group=TKIP)
Determines if the printer can use either TKIP or AES for
data encryption, depending on the configuration of the
access point.
Disable
Setting Description Default