User Manual
Table Of Contents
- Before You Begin
- Chapter 1 — About the Printers
- Chapter 2 — Set Up the Printer
- Adjust the Media Holders
- Load Media for Straight-Through Printing
- Load Media for Cut-Off Printing
- Load Media for the Label Dispenser
- Load Ribbon
- Use External Media
- Connect the Printer to Power
- Use the Setup Wizard
- Print Print Quality Labels from the Main Menu
- Print Configuration Labels from the Main Menu
- Media Settings
- Chapter 3 — Connect the Printer
- Chapter 4 — Configure the Printer
- Chapter 5 — Troubleshoot the Printer
- Chapter 6 — Maintain the Printer
- Appendix A — Specifications and Default Settings
- Printer Specifications
- Supported Bar Code Symbologies
- Bluetooth Settings
- Display and Audio Settings
- Error, Information, and Warning Alert Settings
- Ethernet Settings
- General System Settings
- Media Settings
- Print Quality Settings
- Serial Port Settings
- System I/O Settings
- System Network Services
- System Maintenance Alert Settings
- Wireless 802.11 General Settings
- Wireless 802.11 Network Settings
- Wireless 802.11 Security Settings
- Appendix B — Print Labels with INPrint
Appendix A — Specifications and Default Settings
144 PC23 and PC43 Desktop Printer User Manual
• RFID Not Installed
• Printhead Lifted
• Printhead Not Detected
• Motor Too Hot
• Power Supply Too Hot
Information Alerts
Information alerts are sent when a print job is started or completed, or
when the printer is rebooting. These alerts include:
• Print Job Complete
• Printer is Rebooting
• Started (Sent when a print job has begun)
Warning Alerts
Warning alerts are sent when the printer may need attention shortly,
such as when the printhead needs maintenance, or when the odometer
has reached a present value. A warning alert is also sent when the
printer firmware is being upgraded. Warning alerts include:
• Ribbon Installed (Sent when the printer is set for direct thermal
printing but has ribbon installed for thermal transfer printing)
• Ribbon Low
• Upgrading Firmware
• Odometer (User Resettable)
• Odometer (Printer)
• Replace Printhead
• Clean Printhead
• Faulty Dot (Sent when a faulty dot is detected in the printhead,
which can lead to lower print quality)