User Manual

Appendix A — Specifications and Default Settings
PC23 and PC43 Desktop Printer User Manual 151
System I/O Settings
This section describes system I/O settings for the printer. To view these
settings:
• From the printer Main Menu, select Settings > System Settings >
Manage I/O.
• From the printer web page, click the Configure tab > System
Settings > Manage I/O.
Stop Bits Number of bits sent at the end of every character to allow the
receiving signal hardware to detect the end of a character and to
resynchronize with the character stream.
1
Hardware Specifies if hardware flow control (RTS/CTS) is used to manage
the rate of data transmission between the device and the host.
Disable
ENQ/ACK Specifies if software flow control (ENQ/ACK) is used to manage
the rate of data transmission between the device and the host.
Disable
XON/XOFF To Specifies if software flow control (XON/XOFF) is used to manage
the rate of data transmission to the host.
Disable
XON/XOFF From Specifies if software flow control (XON/XOFF) is used to manage
the rate of data transmission from the host.
Disable
New Line Character Defines the characters that the printer echoes to the host to
indicate that it has moved to a new line.
CR/LF
Setting Description Default
Setting Description Default
Wireless 802.11 Determines if the printer is allowed to communicate using its
802.11 radio. Supported only if the optional Wi-Fi+Bluetooth
module is installed.
Enable
Bluetooth Determines if the printer is allowed to communicate using its
Bluetooth radio. Supported only if the optional Wi-Fi+Bluetooth
module is installed.
Enable
RFID Determines if the printer is allowed to communicate using its RFID
radio. Supported only if the RFID module is installed.
Enable
Virtual COM Determines if you can enable the USB port to be used as a virtual
serial port.
Disable