User Manual
Table Of Contents
- Before You Begin
- Chapter 1 — About the Printers
- Chapter 2 — Set Up the Printer
- Adjust the Media Holders
- Load Media for Straight-Through Printing
- Load Media for Cut-Off Printing
- Load Media for the Label Dispenser
- Load Ribbon
- Use External Media
- Connect the Printer to Power
- Use the Setup Wizard
- Print Print Quality Labels from the Main Menu
- Print Configuration Labels from the Main Menu
- Media Settings
- Chapter 3 — Connect the Printer
- Chapter 4 — Configure the Printer
- Chapter 5 — Troubleshoot the Printer
- Chapter 6 — Maintain the Printer
- Appendix A — Specifications and Default Settings
- Printer Specifications
- Supported Bar Code Symbologies
- Bluetooth Settings
- Display and Audio Settings
- Error, Information, and Warning Alert Settings
- Ethernet Settings
- General System Settings
- Media Settings
- Print Quality Settings
- Serial Port Settings
- System I/O Settings
- System Network Services
- System Maintenance Alert Settings
- Wireless 802.11 General Settings
- Wireless 802.11 Network Settings
- Wireless 802.11 Security Settings
- Appendix B — Print Labels with INPrint
Chapter 3 — Connect the Printer
82 PC23 and PC43 Desktop Printer User Manual
About Bluetooth Communications
The printer supports Bluetooth communications when the optional
Wi-Fi/Bluetooth module is installed. When Bluetooth is enabled, you
can connect the printer to other Bluetooth devices, such as bar code
scanners and keyboards. You can also make the printer discoverable by
Bluetooth-enabled devices such as mobile computers.
Server Common
Name 1
Sets the certificate name that is on the
primary authentication server. If this
value is none, then the value for Server
Common Name 2 is used. Range is 1 to 96
characters.
None
Server Common
Name 2
Sets the certificate name that is on the
secondary authentication server. If this
value is none, then the value for Server
Common Name 1 is used. Range is 1 to 96
characters.
None
Validate
Certificate
Determines if the identity of the
authentication server is verified using its
certificate when using EAP-TTLS, PEAP,
or EAP-TLS. Intermec recommends that
you set Validate Certificate to Yes.
No
PAC Sets the name of the Protected Access
Credential (PAC) that is used for
EAP-FAST authentication. The printer
uses this file if Acquire PAC is on and the
current installed PAC fails to authenticate
the printer to the network.
eap-fast.pac
Acquire PAC Determines if automatic PAC file
provisioning is on for EAP-FAST
authentication.
On
Fast Roaming
(CCKM)
Determines if the printer can roam from
one access point to another without
reauthenticating with the server. CCKM
only works in wireless networks using
LEAP.
Disable
Mixed Mode
(Group=TKIP)
Determines if the printer can use either
TKIP or AES for data encryption,
depending on the configuration of the
access point.
Disable
Setting Description Default