User`s manual

Appendix A — Specifications
PX4i and PX6i High Performance Printer User’s Manual 153
Accessories for the Printer
You can use these accessories (sold and ordered separately) with the
printer. To order accessories, contact your local Intermec sales
representative.
Liner/Batch Takeup
This factory-installed option separates labels from the liner and winds
up the spent liner inside the printer’s media compartment. For more
information on using the liner/batch takeup, see “Loading Media
for Internal Batch Takeup Printing” on page 32.
Paper Cutter
Use the paper cutter to cut through continuous non-adhesive paper-
based media or the liner between labels.
If you are running Fingerprint or Direct Protocol, you can control the
paper cutter using the commands CUT, CUT ON, and CUT OFF. For
help, see the Intermec Fingerprint Command Reference Manual.
Media Roll Retainer
Use the media roll retainer with a rotating media supply hub to keep
large media rolls in place.
76 mm (3-in) Adapter
Use the 76 mm (3-in) adapter with a rotating media supply hub to use
media rolls with 76 mm (3-in) inner diameter cores. The adapter
cannot be used with a media supply roll post.
Internal Fanfold Guides
Use the internal fanfold guides to facilitate loading media from an
external supply. The internal fanfold guide cannot be used in peel-off
(self-strip) mode or with the label slack absorber.
Label Taken Sensor
The label taken sensor (LTS) is a photoelectric sensor that enables the
printer’s firmware to detect if the last printed label, ticket, tag, etc. has
been removed before printing another copy. The LTS cannot be used
with a paper cutter.