User`s manual

Chapter 1 — Using the Printer
8 PX4i and PX6i High Performance Printer User’s Manual
• Peel-off (self-strip)
• Cut-off
• Batch take-up
• External supply
• RFID
If you are using Fingerprint, use the F key to load the same type of
media. If you change the media type, or if the printer does not feed the
media properly, simultaneously press the S and F keys to perform
a “testfeed.”
If you are using IPL, save the label with the sensitivity number
attached to the media roll. You need this number to set the media
sensitivity.
Loading Media for Tear-Off Printing
In tear-off, or straight-through, printing mode, you manually tear off
the media against the printer’s tear bar. In tear-off mode, use these
types of media:
• Non-adhesive continuous stock
• Self-adhesive continuous stock with liner
• Self-adhesive labels with liner
• Tickets with gaps (gap stock), with or without perforations
• Tickets with black marks (mark stock), with or without
perforations
You can also install an optional label taken sensor so that the next
copy in the batch is not printed until the current copy is removed. For
more information, see “Accessories for the Printer” on page 153.
If you are running Fingerprint, use the F key to load the same type
of media. If you switch to a new type of media, or if the printer does
not feed out the media properly, simultaneously press the S and F
keys to perform a “testfeed.”
If you are running IPL, save the label indicating the sensitivity number
attached to the media roll. You need this number to set the media
sensitivity.