99 Series Rev. 3/99 USER MANUAL FOR THE METRO C199 AND FL199 SERIES INSULATED HEATED CABINETS Recommended Food Holding Guidelines Listed on pages 5 & 6.
TABLE OF CONTENTS SECTION SAMPLE OF CABINET LABELING C199-HM2000 = Full Height, Holding C199T-HM2000 = 3/4 Height, Holding PAGE I. Introduction A. Identifying Your Cabinet ............................... 1 B. Features ....................................................... 2 II. Operating Instructions A. Reversible Doors ......................................... 2 B. Slide Rack Assemblies ................................ 2 C1. HM2000 Holding Module ............................. 3 C2.
degrees and mount in the position of the top door. Align the door mounted hinge part with the cabinet mounted hinge part and tap the hinge pin into place so top of pin is flush with top of the cabinet mounted hinge part. B. FEATURES — ALL MODELS In order to utilize your new cabinet to its full potential, take a minute to identify the following features which have been provided for your convenience. • The module has been placed at the base of the cabinet for easy accessibility and efficient operation. 7.
CVSN/-T/-H — Model V (adjustable) The Model V Slide Rack can be installed in either an inboard or outboard position. Center spacing on slides can be either 3" or 41/2". Slides can be removed by lifting upward and sliding the rivet heads out of the keyhole slots. To install, select spacing, insert the rivet heads into the keyhole slots and push down until locked in the hole. All pans are to be bottom loaded regardless of slide or rack positioning. C1.
temperature knob clockwise to increase and counter-clockwise to decrease temperature. 5. The humidity can be adjusted by turning the humidity knob clockwise to increase and counter-clockwise to decrease humidity. If you wish to hold food without using humidity, turn the Humidity control to MIN. This will prevent the cabinet from introducing additional humidity. 6. A buzzer alarm is located in the module to indicate low water level. Refilling the bottle will turn the buzzer off.
9. To install the module, reverse step 8. When installing the module into the cabinet, the cord must be fed through the opening in the cabinet back panel. Be careful that the seals on the side of the module go inside the module slides. To descale the humidity generator: To clean the humidity generator, use a commercially available descaling solution that is compatible with the stainless steel humidity generator and the aluminum cabinet interior.
III. FOOD HOLDING GUIDELINES A.
IV. CLEANING INSTRUCTIONS If cleaning has been postponed, solvent or emulsion type cleaners that can be applied with bare hands will give excellent results. Such cleaners are available under various brand names and detergent suppliers can recommend materials appropriate for use on natural and epoxy-coated aluminum. NOTE: For every cleaning method, best results are always obtained when the cleaner and technique are matched to the soil conditions involved.
VI. REPLACEMENT PARTS, PROCEDURES AND WIRING DIAGRAMS A. CABINET — ALL MODELS Refer to the Cabinet Replacement Parts Diagram on next page to identify the replacement parts.
CABINET REPLACEMENT PARTS LIST (1/2 & 3/4 height cabinet parts not shown) Item No. Part No.
c. Remove the water pan/water bottle and drain water. B. MODULE Your module has been designed to be userservicable, assuming a basic knowledge of the operation of electrical devices. This section has been written to guide the user step by step, and in layman’s terms, through the dismantling and servicing of the module. Before attempting to service your module, read the appropriate Module Repair Procedures (found elsewhere in this section) thoroughly.
Holding Module Replacement Parts Diagram REPLACEMENT PARTS LIST Item No. 1 2 3 4 5 6 7 8 9 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Part No.
VI.
FL2000 High Humidity Module Replacement Parts Diagram REPLACEMENT PARTS LIST Item # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 33 21 25 23 22 24 8 15 7 13 14 20 2 18 20 1 AIR INTAKE COVER Part # RPC13-099 RPC13-098 RPC06-746 RPC13-132 RPC13-181 RPC13-105 RPC11-398 RPC13-169 RPHM20-2103 RPC13-166 RPC09-117 RPC13-167 RPC13-168 RPFL-3/8TUBE RPC13-096 RPHHM-WBA RPC15-024 RPFL20-RMS RPFL20-SMS RPC13-134 RPC13-172 RPC13-129A RPC13-173 RPC13-174 RPC13-171
BLOWER DUCT ELEMENT ELEMENT HI-TEMPERATURE CUT-OUT SWITCH BUZZER STEAMER HI-TEMPERATURE CUT-OUT SWITCH LEAD CORD 3 9 2 8 7 4 10 14 WHITE BLACK POWER SWITCH 18 17 16 15 13 24 23 22 21 20 19 18 12 6 6 24 17 11 5 12 WHITE 23 22 21 20 19 16 14 13 15 10 4 TERMINAL BLOCK 2 3 9 1 8 1 7 GREEN BLACK 1 0 WHITE PERCENTAGE TIMER TRANSFORMER 24V AC - + LOAD 24V AC RELAY SWITCHING 110V AC 8 6 4 2 THERMOMETER POWER SUPPLY 6V DC OUTPUT BLACK 2 6 3 4
Thank you for purchasing a Metro Mobile Heated Cabinet. We are certain you will be more than satisfied with its quality and performance. Please fill in the warranty information space below so we may register your warranty. Also, so that we may learn more about our customers and hopefully be of continued service in the future, please take a moment to fill in the customer information space below. Thank You CUT ALONG DOTTED LINE CUT ALONG DOTTED LINE CUSTOMER INFORMATION 1.
STAPLE HERE STAPLE HERE STAPLE HERE FOLD HERE — DO NOT DETACH NO POSTAGE NECESSARY IF MAILED IN THE UNITED STATES BUSINESS REPLY MAIL FIRST-CLASS PERMIT NO.
Warranty WARRANTY, EXCLUSION OF WARRANTIES AND LIMITATION OF LIABILITY. InterMetro Industries Corporation (hereinafter referred to as “Seller”) warrants to the original purchaser that all products in its catalog, or custom products, delivered hereunder will be free from defects in workmanship and material. THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, EXPRESS, IMPLIED OR STATUTORY, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
® InterMetro Industries Corporation North Washington Street, Wilkes-Barre, PA 18705 For Product Information Call: 1-800-433-2232 Visit Our Web Site: www.metro.com L01-386 Rev. A 03/03 Information and specifications are subject to change without notice. Please confirm at time of order.
