Troubleshooting Guide
Table Of Contents
- Finding information with Access ThinkPad
- Contents
- Chapter 1. Overview of your new ThinkPad computer
- Chapter 2. Solving computer problems
- Diagnosing problems
- Troubleshooting
- Error codes or messages
- Errors without codes or messages
- Password problems
- A power switch problem
- Keyboard problems
- TrackPoint problems
- Infrared port problems
- Standby or hibernation problems
- Computer screen problems
- Battery problems
- Hard disk drive problems
- CD-ROM, DVD-ROM, CD-RW, DVD/CD-RW drive problems
- Software problems
- Other problems
- Starting BIOS Setup Utility
- Recover pre-installed software
- Installing a new operating system and device drivers
- Backing up your system
- Replacing the hard disk drive
- Replacing the battery
- Chapter 3. Getting help and service from IBM
- Appendix A. Important safety instructions
- Appendix B. Warranty Statement
- Warranty Period
- IBM Statement of Limited Warranty
- Notices
- Processing date data
- References to the Web site addresses
- Electronic emission notices
- Telecommunication notices
- Industry Canada requirements
- Notice for Australia
- Regions where ThinkPad R30 has ThinkPad modem integrated
- Notice to New Zealand users
- Notice for European Union countries
- Wireless Interoperability
- Usage environment and your Health
- Wireless Regulatory information
- USA - Federal Communications Commission (FCC)
- Canada – Industry Canada (IC)
- Notice to EMEA users
- Trademarks
- Index
If the power-on password prompt does not appear, the brightness control
might be set to minimum brightness. Adjust the brightness level by pressing
Fn+Home.
If the screen still remains blank, make sure that:
v The battery is installed correctly.
v The ac adapter is connected to the computer and the power cord is plugged
into a working electrical outlet.
v The computer power is on. (Turn on the power switch again for
confirmation.)
If these items are properly set, and the screen remains blank, have the
computer serviced.
Problem: When I turn on the machine, nothing appears on the screen, but I
hear two or more beeps or a continuous beep while starting up.
Solution: If you are using Ethernet:
v Make sure that the Ethernet cable is connected firmly.
v Contact your network administrator.
If the screen is still blank, and beeps are not stopped, have the computer
serviced.
Problem: When I turn on the machine, only a white cursor appears on a
blank screen.
Solution: First, reboot your system by pressing Ctrl+Alt+Del. If that does not
work, hold down the power switch for more than 4 seconds. If this does not
resolve the problem, you may need to reinstall your operating system.
Problem: My screen goes blank while the computer is on.
Solution: Your screen saver or power management may be enabled. Move the
TrackPoint or press a key to exit the screen saver, or press the power switch to
resume from standby or hibernation.
Problem: The computer cannot boot-up.
The message ″Insert system diskette and press Enter key to reboot″ appears.
Solution: Have in hand a bootable diskette, such as the Windows startup
diskette, and do as follows:
1. Turn off the computer.
Solving computer problems
16
ThinkPad
®
R30 Service and Troubleshooting Guide