ASSEMBLY INSTRUCTIONS WARNING! Serious or fatal injuries can occur from furniture tip over. Use tip over restraint (steel band included) to secure this product to the wall. Description Item No. : BROOKLYN 4 DRAWER CHEST : BD-8004 Printed in Vietnam ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description A Top C Bottom panel E Qty Sketch NO Description Qty B Side panel (L-R) 2 1 D Center panel 1 Support bar 4 F Drawer front 4 G Drawer side (L-R) 8 H Drawer back 4 I Drawer bottom 4 J Back panel upper 1 K Back panel lower 1 1 Sketch Printed in Vietnam ITEM NO.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Allen key (M4 x 30mm x 110mm) 3 5 7 9 Sketch NO Description Qty 1 2 Bolt (M6 x 30mm) 12 Spring washer (6.5 x11mm) 12 4 Flat Washer (6.
STEP 1 Attach top (A), and center panel (D) and bottom panel (C) to side panel (B) with bolts (2), and washers (3) and (4) as shown below. Tighten with Allen key (1). Slide back panel (J) and (K) into the grooves as shown below. STEP 2 Attach bottom panel (C), and center panel (D) and top (A) to the other side panel (B) with bolts (2), and washers (3) and (4) as shown below. Tighten with Allen key (1). Printed in Vietnam ITEM NO.
STEP 3 Attach drawer sides (G) to drawer front (F) with screws (5) as shown below. Tighten with a screwdriver. Insert drawer bottom (I) into the grooves at bottom of drawer sides (G) and drawer front (F) as shown below. STEP 4 Attach drawer back (H) to drawer sides (G) with screws (5) as shown below. Tighten with a screwdriver. STEP 5 Attach support bars (E) to bottom of drawers with screws (8) as shown below. Tighten with a screwdriver. Printed in Vietnam ITEM NO.
STEP 6 Attach knobs (7) to front of drawers with pan head screws (6) as shown below. Tighten with a screwdriver. Carefully put the drawers into the unit. STEP 7 Attach steel bands (9) to the unit with screws (10) as shown below. (to secure the product to the wall and reduce the risk of tipping over).