ASSEMBLY INSTRUCTIONS Description : ENTRY BENCH Item No.: BE-150 ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Long bolt (M6x30mm) 16 3 Flat washer (ɸ6.5x13mm) 16 5 Allen key (4mm) 1 Sketch NO Description Qty Sketch Lock washer 2 16 (ɸ6.5x11mm) 4 Screw (M4x15mm) 4 STEP 1 Attach vertical panels (C) to bottom panel (D) with bolts (1) and washers (2) and (3) as shown below. Tighten with Allen key (5).
STEP 2 Attach side panels (B) to bottom panel (D) with bolts (1) and washers (2) and (3) as shown below. Tighten with Allen key (5) STEP 3 Attach back panel (E) into groove of the unit. Attach top (A) to the unit with bolts (1) and washers (2) and (3) as shown below .Tighten with Allen key (5) ITEM NO.
STEP 4 Attach back panel (E) to the unit with screws (4) as shown below .Tighten with a screwdriver. ITEM NO.