ASSEMBLY INSTRUCTIONS Description : SINGLE JELLY CUPBOARD RTA Item No. : CU-120 ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top C Sketch NO Description Qty 1 B Shelf 1 Bottom shelf 1 D Side panel (L-R) 2 E Back panel 1 F Door G Adjustable shelf 2 H Rail ITEM NO.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Bolt (M6 x 35mm) 3 Sketch NO Description Qty 12 2 Lock washer (ɸ6.5 x 11mm) 12 Flat washer (ɸ6.5 x 19mm) 12 4 Long screw (M4 x 35mm) 4 5 Short screw (M3.5 x 15mm) 19 6 Short pan head screw (M3.
STEP 1 Insert rail (H) into side panels (D) as shown below. Then attach shelf (B) and bottom shelf (C) to side panels (D) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (7). STEP 2 Attach rail (H) to top (A) with screws (4) as shown below. Tighten with a screwdriver. Then attach side panels (D) to top (A) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (7). Slide back panel (E) into the grooves of top (A) and side panels (D).
STEP 3 Attach door (F) to the unit with screws (5) as shown below .Tighten with a screwdriver STEP 4 Attach knob (8) to door (F) with pan head screw (9) as shown below. Tighten with a screwdriver. Attach brackets (11) to side panels (D) as shown below. Then place the adjustable shelves (G) on the brackets and attach with screws (5). Tighten with a screwdriver.