ASSEMBLY INSTRUCTIONS Description Item No : BROOKLYN DESK 48X20X30H : OF-66 ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top B Sketch NO Description Qty 1 G Back panel 1 Side frame 1 H Side frame 1 C Connecter 1 I Drawer 1 D Vertical panel 1 J Bottom frame 1 E Drawer bottom 1 K Drawer front 1 F Drawer back 1 L Drawer side (L-R) 2 ITEM NO.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Bolt (M6 x 35mm) 20 Sketch NO 6 2 Spring washer (6.5 x 13mm) 20 Description Qty Wooden knob (30 x 30mm) 3 Sketch METAL KNOB (30 x 30mm) GOES WITH FINISHED 3 ITEM ONLY. 3 Flat Washer (6.
STEP 2 Attach back panel (G) to vertical panel (D) and side frame (H) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (8). STEP 3 Attach bottom frame (J) to the vertical panel (D) and side frame (H) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (8). ITEM NO.
STEP 4 Insert connecter (C) into vertical panel (D) and side frame (B) as shown below. Attach side frame (B) to the top (A) and back panel (G) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (8). STE STEP 5 Attach connecter (C) to vertical panel (D) and side frame (B) with screws (4) as shown below. Tighten with a screwdriver. Attach back panel (G) to the top (A) with screws (4) as shown below. Tighten with a screwdriver. ITEM NO.
STEP 6 Attach drawer sides (L) to drawer back (F) with screw (5) as shown below. Tighten with a screwdriver. STEP 7 Slide drawer bottom (E) into the grooves as shown below. STEP 8 Attach drawer front (K) to drawer sides (L) with screw (5) as shown below. Tighten with a screwdriver. ITEM NO.
STEP 9 Attach knobs (6) to front of drawers with pan head screws (7) as shown below. Tighten with a screwdriver. Carefully put the drawers into the unit. STEP 10 NOTE: Put your hands in front of the drawer and open the flip down key board tray as shown below . ITEM NO.
