ASSEMBLY INSTRUCTIONS Description Item No. : 24 IN SAN REMO SWIVEL STOOL : S-102SW ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following parts: NO Description Qty A Chair back C E Sketch NO Description Qty 1 B Seat Frame 1 Leg 1 D Leg 1 Stretcher 4 F Chair Seat 1 Sketch HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging.
STEP 1 Attach seat frame (B) to the back (A) with bolts (2) and (3), and washers (5) and (6), as shown below. Tighten with Allen key (7). Note: DO NOT tighten any of the bolts, until the stool is assembled, then put on a flat level surface to make sure the stool is level and then tighten the bolts. STEP 2 Attach the leg (C) to the leg (D) with bolts (2), and washers (5) and (6) as shown below. Tighten with Allen key (7). Place stretchers (E) between legs (C) and (D), attach with screws (4) as shown below.
STEP 3 Attach the swivel plate underneath the seat frame (B) to legs (C) and (D) with bolts (1), and washers (5) and (6) as shown below. Tighten with Allen key (7). STEP 4 Attach the seat (F) to top of the seat frame (B) with screws (4). Tighten with a screwdriver. ITEM NO.
