ASSEMBLY INSTRUCTIONS Description Item No. : 36 IN PLATE SHELF : SH-136 ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top 1 C Back 1 Sketch NO Description Qty B Side (L-R) 2 Sketch HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Screw (M4 x 35mm) 10 Sketch ITEM NO.
STEP 1 Attach sides (B) to back (C) with screws (1) as shown below. Tighten with a screwdriver. STEP 2 Attach back (C) to the top (A) with screws (1) as shown below. Tighten with a screwdriver. ITEM NO.
STEP 3 Mark the two center points of the keyholes on the wall with a pencil based on the measurement of the back of the shelf. Drill two hole(s) into the wood stud(s) located in the wall, where you marked with the pencil. Insert plastic dowels (2) and screws (1) into the wall as shown below. ITEM NO.
STEP 4 Push the shelf onto the screws, then carefully pull the shelf down so that the screw heads slip up into the narrow part of the keyholes to lock the shelf in place. ITEM NO.
