ASSEMBLY INSTRUCTIONS Description Item No. : 32 X 12 X 72 HIGH BOOK CASE RTA : SH-3227A ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PARTS LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following parts: NO Description Q’ty A Top C NO Description Q’ty 1 B Side panel (L-R) 2 Bottom panel 1 D Shelf panel 2 E Back upper (Large) 1 F Back center (Small) G Back lower (Small) 1 H Connecter I Adjustable shelf Sketch Sketch 1 2 3 ITEM NO.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Q’ty 1 Bolt (M6 x 30mm) 3 Sketch NO Description Q’ty 16 2 Lock washer (6.5 x11mm) 16 Flat washer (6.5 x13mm) 16 4 Allen Key (M4 x 110mm) 1 5 Shelf support bracket 12 6 Short screw M3.5 x 15mm 16 7 Long screw (M4 x 30mm) 2 8 Steel band 2 9 Medium screw (M4 x 20mm) 17 10 Flat washer (6.
STEP 2 Slide back panels (E), and (F) and (G) into the grooves as shown below . Attach back panel (G) to bottom panel (C) with pan head screws (9). Then attach back panels (E), and (F) and (G) to shelf panels (D) with pan head screws (9) and washers (10) as shown below. Tighten with a screwdriver. Remove the paper strip and attach sticky side of connecters (H) to back of the unit. Then attach connecters (H) to the top (A), and bottom panel (C) and shelf panels (D) with pan head screws (9) as shown below.
STEP 3 Attach brackets (5) to the unit as shown below. Then place the shelves (I) on the brackets and attach with screws (6). Tighten with a screwdriver. Attach steel bands (8) to the unit with screws (6). Then attach the steel bands to a wall with screws (7) as shown below (to secure the product and prevent tipping). Tighten with a screwdriver. ITEM NO.