ASSEMBLY INSTRUCTIONS Description : 36 X 36 SQUARE DROPLEAF PED TABLE Item No.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Large Flat Washer (8.5x19mm) 3 Sketch NO Description Qty 4 2 Large Lock Washer (8.5x13mm) 4 Hexagon Nut (M8 x13mm) 4 4 Wrench (13mm) 1 5 Small Flat Washer (6.5x13mm) 4 6 Small Lock Washer (6.5x11mm) 12 7 Medium Flat Washer (6.
STEP 2 Attach the mouting plate (D) on top of the pedestal (C) with washers (5) and (6), and bolts (8), as shown below. Tighten with the Allen key (9). Insert the wood slides (E) into the groove of the mouting plate. STEP 3 Carefully place the pedestal on the bottom side of the table top. Attach the top (A) to mounting plate with bolts (8), and washers (6) and (7).
STEP 4 Hold the dropleaf push and slide the wooden piece from underneath the table top . To lower the dropleaf, carefully hold the dropleaf with one hand and slide the wooden piece from underneath the table top towards the center of the top. Then, gently lower the leaf and place in the down position.
