ASSEMBLY INSTRUCTIONS Description Item No.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Long Bolt (M6x100mm) 3 5 7 NO Description Qty 2 2 Lock washer (6.5x11mm) 14 Small Flat washer (6.5x13mm) 6 4 Large Flat washer (6.5x19mm) 8 Short Bolt (M6x45mm) 12 6 Allen key (M4x80mm) 1 Wood button (14.
STEP 2 Place the plate on top of the pedestal (E), attach with short bolts (5) , and washers (2) and (3) as shown below. Tighten with the Allen key (6). Insert the wood slides (F) into the groove of the mouting plate. STEP 3 Carefully place the base (from step 2) on the bottom side of the top (A). Attach the mounting plate to top (A) with short bolts (5) and washers (2) and (4). Tighten with Allen key (6).
STEP 4 Insert wood buttons (7) over bolts to cover them. Hold the dropleaf push and slide the wooden piece from underneath the table top. To lower the dropleaf, carefully hold the dropleaf with one hand and slide the wooden piece from underneath the table top towards the center of the top. Then, gently lower the leaf and place in the down position.
