ASSEMBLY INSTRUCTIONS Description Item No. : MISSION CORNER TV STAND : TV-27 ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top B NO Description Qty 1 F Shelf 1 Side frame (L-R) 2 G Drawer side (L-R) 2 C Supporting bar 1 H Drawer front 1 D Bottom panel 1 I Drawer bottom 1 Back panel 1 J Drawer back 1 E Sketch Sketch HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging.
STEP 1 Attach bottom panel (D) to side frames (B) with bolts (1) and washers (5) and (6) as shown below. Tighten with Allen key (3). Attach supporting bar (C) to side frames (B) with screws (2) as shown below. Tighten with a screwdriver. STEP 2 Slide back panel (E) into grooves of side frames (B) as shown below. ITEM NO.
STEP 3 Attach top (A) to side frames (B) with bolts (1) and washers (5) and (6) as shown below. Tighten with Allen key (3). STEP 4 Attach brackets (7) to side frames (B) as shown below. Then place shelf (F) on the brackets and attach with screws (4). Tighten with a screwdriver. ITEM NO.
STEP 5 Attach back panel (E) to the unit with screws (4). Tighten with a screwdriver. STEP 6 Attach drawer sides (G) to drawer front (H) with screws (9) as shown below. Tighten with a screwdriver. ITEM NO.
STEP 7 Slide drawer bottom (I) into grooves of drawer sides (G) and drawer front (H) as shown below. STEP 8 Attach the drawer back (J) to the drawer sides (G) with screws (9) as shown below. Tighten with a screwdriver. ITEM NO.
STEP 9 Attach knob (10) to front of drawer with pan head screw (8) as shown below. Tighten with a screwdriver. STEP 10 Carefully put the drawer (from step 9) into the unit. ITEM NO.