ASSEMBLY INSTRUCTIONS Description Item No : 48 IN TV STAND RTA : TV-34 Printed in Vietnam ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top B Sketch NO Description Qty 1 F Side panel (L-R) 2 Bottom panel 1 G Vertical panel (L-R) 2 C Center shelf 2 H Side shelf 2 D Door (L-R) 2 I Center back panel (L-R) 2 E Glass 2 J Side back panel 2 K H - Connector 1 Printed in Vietnam ITEM NO.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Bolt (M6x35mm) 2 NO Description Qty 16 9 Short pan head screw (M3x15mm) 10 Spring washer (6.5x13mm) 16 10 Screw (M3x15mm) 22 3 Flat Washer (6.
STEP 1 Attach glass (E) to back of doors (D), and lock it. Attach knobs (4) to doors (D) with pan head screws (5) as shown below. Tighten with a screwdriver. STEP 2 Attach panels (G) to top (A) and bottom panel (B) with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (8). Attach doors (D) (from STEP 1) to top (A) and bottom (B) with door pins (6). Attach magnets (11) to top (A) with screws (10) as shown below. Tighten with a screwdriver. Printed in Vietnam ITEM NO.
STEP 3 Attach side panels (F) to the unit with bolts (1), and washers (2) and (3) as shown below. Tighten with Allen key (8). STEP 4 Slide center back panels (I) into groove of H-connector (K). Then slide center back panels (I) into groove of panels (F). Attach center back panels (I) to bottom (B) with screws (9). Attach H-connecter to top (A) and bottom (B) with screws (15) as shown below. Tighten with a screwdriver. Slide side back panels (J) into grooves of panels (G) and (F).
STEP 5 (FINISH) Stick Warning labels (14) on the back side of doors before use. Insert brackets (12) into the unit as shown below. Place shelves (C) and (H) on the brackets and attach with screws (10). Tighten with a screwdriver. Attach steel band (13) to the unit with screws (10). Then attach the steel band to a wall with screw (7) as shown below (to secure the product and prevent tipping). Tighten with a screwdriver. Printed in Vietnam ITEM NO.
