User's Manual

Enrollment Station Installation Instructions
Installing the USB Drivers
To use the Enrollment Station you must install the USB drivers on the PC. The Enrollment Station is plug and play, so when you plug
it in, your PC should recognize the new hardware and launch the Found New Hardware Wizard as shown below. Please note that this
hardware wizard runs twice. Follow the same steps both times. Note: These instructions are for a typical Windows XP system. If
you are using a different operating system, or these steps do not match your PC, please refer to the instructions for your system.
On the first screen of the wizard select “No, not this time.” then click the Next button.
After clicking the Next button, choose the option that says “Install from a list or specific location (Advanced)” and click the Next
button.
Document # 6045680 Rev. 2.0, D2c Page 5 of 10